| Assessment Year | 1995 |
|---|---|
| Principal Product | Blow and injection molded plastics |
| NAICS |
n/a
|
| SIC | 3089: Plastics Products, Not Elsewhere Classified |
| Sales Range | $500 k to 1M |
| # of Employees | 20 |
| Plant Area |
9,200
ft2
|
| Annual Production | 1,130,000
lb
|
| Production Hrs. Annual | 6,120
hrs
|
| Location (State) | Missouri |
Facility Energy Cost and Usage
| Source | Yearly Cost | Usage | Unit Cost | |
|---|---|---|---|---|
| Electricity Usage | $84,955 | 1,325,909 |
kWh
|
$0.064 |
| Natural Gas | $10,512 | 2,241 |
MMBtu
|
$4.69 |
| TOTAL YEARLY COSTS | - | |||
| RECOMMENDED SAVINGS* | $10,558 |
See individual recommendations below
*Non-energy impacts included in savings.
|
||
| IMPLEMENTED SAVINGS* | $10,492 | |||
Recommendations
| # | Description | Yearly Savings* | Imp'd Cost* | Status | Electricity Usage Savings | Water Disposal Savings |
|---|---|---|---|---|---|---|
| 01 | 2.4133: Use most efficient type of electric motors | $3,712 | $4,635 |
$3,712
60,082
kWh
|
- | |
| 02 | 2.4236: Eliminate leaks in inert gas and compressed air lines/ valves | $3,157 | $40 |
$3,157
50,996
kWh
|
- | |
| 03 | 2.4231: Reduce the pressure of compressed air to the minimum required | $1,126 | $40 |
$1,126
18,171
kWh
|
- | |
| 04 | 2.4221: Install compressor air intakes in coolest locations | $1,021 | $395 |
$1,021
16,413
kWh
|
- | |
| 05 | 2.7142: Utilize higher efficiency lamps and/or ballasts | $391 | $926 |
$391
6,448
kWh
|
- | |
| 06 | 2.7142: Utilize higher efficiency lamps and/or ballasts | $211 | $40 |
$211
3,517
kWh
|
- | |
| 07 | 2.7142: Utilize higher efficiency lamps and/or ballasts | $66 | $92 |
$66
1,172
kWh
|
- | |
| 08 | 3.5311: Recover and reuse waste material | $874 | $200 | - |
$874
-
Tgal
|
|
| TOTAL RECOMMENDED | $10,558 | $6,368 |
$9,684
156,799
kWh
|
$874
-
Tgal
|
||
| TOTAL IMPLEMENTED | $10,492 | $6,276 |
$9,618
155,627
kWh
|
$874
-
Tgal
|
||
| Yearly Savings* | Imp'd Cost* | Electricity Usage Savings | Water Disposal Savings | |||
*Savings and costs are best estimates based on the center's site visit, associated engineering analysis, and typical capital and labor costs